Nuc-hatch: a shield for my Nucleo

Wiring the motor driver, encoder and CAN module straight to the Nucleo for the pan tracker got messy fast, and finding the right pin on the Zio headers every time was a pain. There’s only one 3V3 socket on the Zio headers too (CN8-7). I got frustrated and wired out a proto board as a hub. A common thread between posts here: spatial organization is important to me! I can’t stand wire clutter and fragile hardware setups. I digress. ...

November 19, 2026

CAN over a USB-C cable

The CAN transceiver boards on the pan tracker were hanging off loose jumpers, and the bus between the Nucleo and the Jetson was hand-twisted wire. Due to my deep-seated fear of bumping my boards to the point of destruction: I decided to print an enclosure for the motor driver on my new Bambu A1. It went well, so the CAN boards were next. A USB-C cable already has a twisted pair (D+ and D−) and a ground, so I put a USB-C port on the end of the enclosure, and now any USB-C cable is a CAN cable! ...

November 15, 2026